PROCEDURE NO: PR060034 REVISION 3
Page 3 of 15
1.10
Location: Main power compartment
Remove the protective cover
WARNING
LIVE WIRE
This 12-volt terminal remains
energized
Disconnect the electronic ground terminals
from the stud
Using electric tape, insulate the 2 largest
gage wires. Make sure the ring terminals
do not touch each others and the vehicle
body.
NOTE
With disconnection of the electronic
ground terminals, disconnecting the
engine ECM, transmission TCM and the
dashboard electronic components
(telltale module, HVAC module, radio,
control head, …) is not required.
To Next Page
Loading...
Need help?
General
