PREVOST LE MIRAGE XLII BUS SHELLS User Manual

Section 6: ELECTRICAL
PA1553
52
FIGURE 42: HEADLIGHT ASSEMBLY REAR VIEW 06548
Setting aligner according to slope
1. Park vehicle on a level floor.
2. Set the support rail (Prévost #29261) down
(Fig. 43). Using shims, adjust its level to
stabilize it.
FIGURE 43: SUPPORT RAIL INSTALLATION 06501
3. Install jigs #29263 and #29262 onto the
support rail. Position the support rail so that
both stops are centered between the two
beams (Fig. 44). Mark the position for future
reference.
FIGURE 44: INSTALLATION OF JIGS 06499
NOTE
The stops will position the support rail between
16-24 inches of vehicle.
4. Remove the jigs.
5. Install “Hoopy 100” Aligner onto support rail
(Fig. 45).
6. Using an Allen key on the front wheel, level
Hoopy 100 aligner until spirit level bubble is
centered (Fig. 46 and 47).
7. Install a calibration fixture in the axis of front
axle wheel and one in the axis of rear axle
wheel (Fig. 48).
8. Adjust mirrors so that lines are perfectly
aligned.
9. Record reading.
FIGURE 45: INSTALLATION OF HOOPY 100 ALIGNER
06496
FIGURE 46: ADJUSTING HOOPY 100 LEVEL 06498

PREVOST LE MIRAGE XLII BUS SHELLS Specifications

General

Brand	PREVOST
Model	LE MIRAGE XLII BUS SHELLS
Category	Buses
Language	English