PREVOST LE MIRAGE XLII BUS SHELLS User Manual

Section 11: REAR AXLES
PA1553
6
TAG AXLE ALIGNMENT
o Remove and reinstall all wheel mount sensors on the drive and tag axles (fig. 8);
NOTE
For an accurate alignment, the tag axle must be aligned with the drive axle.
NOTE
Reinstall wheel mount sensors as shown in figure 7. For example, the sensor from the right side of the
front wheel is mounted on the right side of the tag axle. For corresponding wheel mount sensor
reference numbers, refer to figure 7.
o Adjust tag axle according to specifications' chart below in reference with drive axle.
TAG AXLE
ALL VEHICLES
Alignment / value Minimum value Nominal value Maximum value
Parallelism (deg.) -0.02 0 0.02
Total Toe (deg.) 0.18 Toe-in 0 0.18 Toe-out
FIGURE 7: DRIVE AXLE ALIGNMENT 11025
FIGURE 8: TAG AXLE ALIGNMENT
11026

PREVOST LE MIRAGE XLII BUS SHELLS Specifications

General

Brand	PREVOST
Model	LE MIRAGE XLII BUS SHELLS
Category	Buses
Language	English