PREVOST LE MIRAGE XLII BUS SHELLS User Manual

20
3
Mounting
tubeless tires
continued
NOTICE: Not all tire
mounting/demounting
machines work alike. Be sure
to read the operating
or instruction manual for your
particular machine before
attempting to mount
or demount tires.
NOTICE: Do not exceed
maximum wheel load.
Customer must compare
OEM vehicle load rating
to maximum wheel load rating.
Refer to tire manufacturer’s
recommendation for proper
tire pressure. Before mounting
the tire perform a wheel
fitment check to insure proper
clearance from any
obstructions.
NOTICE: When match
mounting tires on Alcoa wheels
locate valve stem adjacent
to low point mark on the tire.
NOTICE: Alcoa aluminum 19.5"
RW and non-symmetrical
wide base wheels require tires
to be mounted and demounted
over the disc side of the
wheel only.
NOTICE: Refer to tire
manufacturer’s
recommendation for proper
tire pressure.
NOTICE: Alcoa aluminum 19.5"RW and non-symetrical well wide base wheels require tires be
mounted and demounted over the disc side of the wheel only. For a free instruction wall chart,
contact: Alcoa Inquiry Fulfillment, Markinetics Inc., P.O. Box 809, Marietta, OH 45750.
WARNING Use of a volatile or flammable material, such as ether or gasoline,
as an aid to seating the tire beads on the wheel can lead to an uncontrolled
pressure build-up in the tire and may result in an explosion.
Explosive separation of the tire and wheel can occur while seating beads in this
manner, while adding air to the tire or later on the road. Loss of vehicle control
can result, which can cause serious injury or death.
Use only approved mechanical or pneumatic bead seating devices.
CAUTION The use of liquid tire balancers or sealants in Alcoa wheels may cause
extremely rapid corrosion of the wheel rim surface.
Severely corroded wheels are unsuitable for service. Alcoa wheels corroded by
the use of liquid tire balancers or sealants will not be replaced under the Alcoa
limited warranty.
CAUTION
WARNING
!
Heavy duty truck tires have a “guide rib” molded into the sidewall next to the tire bead. When the tire is inflated this
ring should be evenly spaced from the wheel rim all the way around the wheel. Check the position of the ring before
removing the assembly from the inflation cage. If the ring and wheel are not concentric, deflate the assembly in the
cage and remount the tire.

PREVOST LE MIRAGE XLII BUS SHELLS Specifications

General

Brand	PREVOST
Model	LE MIRAGE XLII BUS SHELLS
Category	Buses
Language	English