R&S ESR Series

Spectrum Measurements
R&S
®
ESR
352User Manual 1175.7068.02 ─ 12
Noise Correction......................................................................................................... 355
Input (AC/DC)..............................................................................................................355
Input 50 Ω/75 Ω ..........................................................................................................355
Ref Level
Opens an edit dialog box to enter the reference level in the current unit (dBm, dBµV,
etc).
The reference level is the maximum value the AD converter can handle without distor-
tion of the measured value. Signal levels above this value will not be measured cor-
rectly, which is indicated by the "IFOVL" status display.
Remote command:
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel on page 845
Range
Opens a submenu to define the display range of the level axis.
●
Range Log 100 dB
●
Range Log 50 dB
●
Range Log 10 dB
●
Range Log 5 dB
●
Range Log 1 dB
●
Range Log Manual
●
Range Linear %
●
Range Lin. Unit
Range Log 100 dB ← Range
Sets the level display range to 100 dB.
Remote command:
Logarithmic scaling:
DISP:WIND:TRAC:Y:SPAC LOG, see DISPlay[:WINDow<n>]:TRACe<t>:Y:
SPACing on page 668
Display range:
DISP:WIND:TRAC:Y 100DB, see DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
on page 844
Range Log 50 dB ← Range
Sets the level display range to 50 dB.
Remote command:
Logarithmic scaling:
DISP:WIND:TRAC:Y:SPAC LOG, see DISPlay[:WINDow<n>]:TRACe<t>:Y:
SPACing on page 668
Display range:
DISP:WIND:TRAC:Y 50DB, see DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
on page 844
Range Log 10 dB ← Range
Sets the level display range to 10 dB.
Configuration