R&S ESR Series

Spectrum Measurements
R&S
®
ESR
389User Manual 1175.7068.02 ─ 12
Functions to configure traces exclusive in Spectrum mode
Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6.......................................................389
└ Clear Write....................................................................................................389
└ Max Hold.......................................................................................................390
└ Min Hold........................................................................................................390
└ Average.........................................................................................................390
└ View.............................................................................................................. 390
└ Blank.............................................................................................................390
└ Hold/Cont......................................................................................................391
└ Detector........................................................................................................ 391
└ Auto Select......................................................................................... 391
└ Auto Peak........................................................................................... 392
└ Positive Peak......................................................................................392
└ Negative Peak.................................................................................... 392
└ Sample................................................................................................392
└ RMS....................................................................................................392
└ Average.............................................................................................. 392
└ Quasipeak...........................................................................................392
└ CISPR Average.................................................................................. 392
└ RMS Average..................................................................................... 393
Average Mode.............................................................................................................393
└ Lin................................................................................................................. 393
└ Log................................................................................................................393
└ Power............................................................................................................394
Trace Math.................................................................................................................. 394
Trace Math Mode........................................................................................................ 394
└ Lin................................................................................................................. 394
└ Log................................................................................................................395
└ Power............................................................................................................395
Trace Math Position.................................................................................................... 395
Trace Math Off............................................................................................................ 395
Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the active trace (1, 2, 3, 4, 5, 6) and opens the "Trace Mode" submenu for the
selected trace.
In the default state, trace 1 is in Clear Write mode. The other traces are turned off. For
details see Chapter 5.2.3, "Trace Modes", on page 171.
Tip: To configure several traces in one step, use the functionality of the Trace Configu-
ration dialog box. To access the dialog box, press the Trace Wizard softkey.
Remote command:
Selected via numeric suffix of:TRACe<1...6> commands
Clear Write ← Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Overwrite mode: the trace is overwritten by each sweep. This is the default setting.
All available detectors can be selected.
Remote command:
DISP:TRAC:MODE WRIT, see DISPlay[:WINDow<n>]:TRACe<t>:MODE
on page 683
Analysis