R&S ESR Series User Manual

System Configuration
R&S
®
ESR
513User Manual 1175.7068.02 ─ 12
IP Address ← Network Address ← General Setup
Opens an edit dialog box to enter the IP address via the keypad. The TCP/IP protocol
is preinstalled with the IP address 10.0.0.10. If the DHCP server is available ("DHCP
On"), the dialog box entry is read-only.
The IP address consists of four number blocks separated by dots. Each block contains
3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the pre-installed address). For step-by-step
instructions, refer to Chapter 11.2.6.2, "Assigning the IP Address", on page 625.
Subnet Mask ← Network Address ← General Setup
Opens an edit dialog box to enter the subnet mask via the keypad. The TCP/IP proto-
col is preinstalled with the subnet mask 255.255.255.0. If the DHCP server is available
("DHCP On"), the dialog box entry is read-only.
The subnet mask consists of four number blocks separated by dots. Each block con-
tains 3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the preinstalled address). For step-by-step
instructions, refer to Chapter 11.2.6, "Setting Up a Network (LAN) Connection",
on page 623.
DHCP (On/Off) ← Network Address ← General Setup
Switches between DHCP server available ("On") or not available ("Off"). If a DHCP
server is available in the network, the IP address and subnet mask of the instrument
are obtained automatically from the DHCP server. For further details, refer to Chap-
ter 11.2.6, "Setting Up a Network (LAN) Connection", on page 623.
LXI ← General Setup
Opens the LXI submenu containing the following softkeys:
●
"Info" on page 513
●
"Password" on page 513
●
"Description" on page 514
●
"LAN Reset" on page 514
LXI functionality is available only for user accounts with administrator rights.
Info ← LXI ← General Setup
Shows the current LXI parameters, including the current version, class and various
computer parameters like the computer name or IP address.
While active, the dialog is not updated.
LXI functionality is available only for user accounts with administrator rights.
Remote command:
SYSTem:LXI:INFo? on page 990
Password ← LXI ← General Setup
Shows the currently set password. You can also change the current password using
this softkey.
The password is required to change settings via the web browser (e.g. IP parameter).
An empty password is not valid, i.e. you must enter a password.
By default, the password is LxiWebIfc.
Instrument Setup and Interface Configuration – SETUP Key

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English