R&S ESR Series User Manual

Remote Control
R&S
®
ESR
921User Manual 1175.7068.02 ─ 12
Example:
SYST:COMP FSP
Usage: SCPI confirmed
Manual operation: See "Compatibility Mode" on page 514
See "Mode Default" on page 515
See "Mode R&S FSP" on page 515
See "Mode R&S FSU" on page 515
SYSTem:DISPlay:UPDate <State>
In remote control mode, this command switches on or off the instrument display. If
switched on, only the diagrams, traces and display fields are displayed and updated.
The best performance is obtained if the display output is switched off during remote
control.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
SYST:DISP:UPD ON
Manual operation: See "Display Update (On/Off)" on page 518
SYSTem:FIRMware:UPDate
This command starts a firmware update using the *.msi files in the selected directory.
The default path is D:\FW_UPDATE. The path is changed via the MMEMory:COMMent
command. To store the update files the MMEMory:DATA command is used.
Only user accounts with administrator rights can perform a firmware update.
Example:
SYST:FIRM:UPD 'D:\FW_UPDATE'
Starts the firmware update from directory "D:\FW_UPDATE".
Usage: Event
Manual operation: See "Firmware Update" on page 525
SYSTem:FORMat:IDENt <Format>
This command defines the response format to the *IDN? on page 916 command. This
function is intended for re-use of existing control programs together with the R&S ESR.
Parameters:
<Format> FSL | LEGacy | NEW
LEGacy
Format is compatible to the R&S FSP/FSU/FSQ family
NEW
R&S ESR format
FSL
Format is compatible to the R&S FSL family
System Configuration

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English