System Configuration
R&S
®
ESR
525User Manual 1175.7068.02 ─ 12
If the number of error messages exceeds the capacity of the error buffer, "Message
buffer overflow" is displayed. To delete messages, see "Clear All Messages"
on page 525 softkey.
Remote command:
SYSTem:ERRor:LIST? on page 927
Clear All Messages ← System Info
Deletes all system messages. The softkey is only available if the "System Messages"
dialog box is displayed.
Remote command:
SYSTem:ERRor:CLEar:ALL on page 926
Parameter Coupling
Opens a dialog box to couple or decouple various parameters.
If the coupling of a parameter is on, its value is transferred when you switch from
receiver into another operating mode and vice versa. Coupling of the following parame-
ters is supported.
●
Frequency
●
Span (start and stop frequencies)
●
Marker frequency
●
RF attenuation and unit
●
10 dB Minimum Attenuation
●
Preamplifier state
●
Preselector state
Note that the preselector is always on in receiver mode.
●
Audio demodulation settings
●
Bandwidth settings (including filter type)
●
Limit lines
Limit lines are only transferred if they are compatible to the current diagram config-
uration.
Remote command:
See Chapter 11.9.3, "Coupling Parameters", on page 927
Firmware Update
Opens the "Firmware Update" dialog box.
Enter the name of or browse for the firmware installation file and press the "Execute"
button. For details on installation, refer to Chapter 3.3, "Firmware Update and Installa-
tion of Firmware Options", on page 60.
Only user accounts with administrator rights can perform a firmware update.
Remote command:
SYSTem:FIRMware:UPDate on page 921
Option Licenses
Opens a submenu to install options. For details on options, refer to Chapter 3.3, "Firm-
ware Update and Installation of Firmware Options", on page 60.
The submenu contains the following commands:
●
"Install Option" on page 526
Instrument Setup and Interface Configuration – SETUP Key
To Next Page
Loading...
Need help?
General
