230 Rockwell Automation Publication 2198-UM002L-EN-P - October 2021
Chapter 6 Configure and Start the Kinetix 5700 Drive System
The Motor Device Specification dialog box appears.
7. From the Data Source pull-down menu, choose Catalog Number.
8. Click Change Catalog.
The Change Catalog Number dialog box appears.
9. Select the motor catalog number appropriate for your application.
To verify the motor catalog number, refer to the motor name plate.
10. Click OK to close the Change Catalog Number dialog box.
11. Click Apply.
Motor data specific to your motor appears in the Nameplate / Datasheet -
Phase to Phase parameters field.
12. For Extended Speed operation, check Extended Speed permissive in the
Extended Speed field. See Phase Loss Detection
on page 432, for more
information.
IMPORTANT
Motor NV is not a supported data source in the Logix Designer
application for axes configured as interior permanent-magnet
(IPM) motor closed-loop. In addition, third-party IPM motors are
not supported.
To Next Page
Loading...
