Rockwell Automation Publication 2198-UM002L-EN-P - October 2021 193
Chapter 6 Configure and Start the Kinetix 5700 Drive System
Configure the Kinetix 5700
Drive Modules
The Kinetix 5700 drive modules consist of the power supply, optional iTRAK
power supply, and inverter modules.
Configure the DC-bus Power Supply
Follow these steps to configure the DC-bus power supply.
1. Below the controller you just created, right-click Ethernet and choose
New Module.
The Select Module Type dialog box appears.
2. By using the filters, check Motion and Allen-Bradley, and select your
2198-Pxxx DC-bus power supply as appropriate for your hardware
configuration.
3. Click Create.
The New Module dialog box appears.
IMPORTANT
To configure Kinetix 5700 drive systems, you must be using the
Logix Designer application, version 26.00 or later.
IMPORTANT
When the iTRAK power supply is configured for Standalone operation,
the Logix Designer application is not used. For more information, see
iTRAK System with TriMax Bearings User Manual, publication
2198T-UM002
.
Enter 2198 here to further
limit your search.
To Next Page
Loading...
