Rockwell Automation Publication 2198-UM002L-EN-P - October 2021 173
Chapter 5 Connect the Kinetix 5700 Drive System
External Active-shunt
Connections
Active shunts are available from the Rockwell Automation Encompass™
partner Powerohm Resistors, Inc. See Active Shunt Considerations
on page 50
for Powerohm shunts compatible with your Kinetix 5700 power supply.
Follow these guidelines when wiring your Powerohm active shunt:
• Refer to External Active Shunt Modules
on page 72 for noise zone
considerations.
• Refer to Active Shunt Wiring Examples
on page 338.
• Refer to the installation instructions provided with your Bulletin
PWBxxx and PKBxxx Powerohm shunt module.
DC-bus Power Supply Active Shunt Connections
Make active shunt connections in drive systems that include the DC-bus power
supply and Powerohm PKBxxx or PWBxxx active shunts at the external DC-bus
studs on accessory modules.
Refer to Wire the External DC-bus Connections
on page 174.
Regenerative Bus Supply Active Shunt Connections
Make active shunt connections to the 2198-RPxxx regenerative bus supply at
the active shunt (RC) connector or the external DC-bus studs on accessory
modules, depending on the shunt type.
Rockwell Automation Encompass Partners Contact Information
Powerohm Resistors, Inc.
5713 13th Street
Katy, Texas 77493
Tel: (800) 838-4694
http://www.powerohm.com
IMPORTANT
To improve system performance, run wires and cables in the wireways
as established in Chapter 2.
To Next Page
Loading...
