EasyManua.ls Logo

SeaDoo 3D - GTI SERIES

SeaDoo 3D
391 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section01MAINTENANCE
Subsection 01 (MAINTENANCE CHART)
GTI SERIES
FIRST 10 HOURS
EVERY25HOURSOR3MONTHS
EVERY 50 HOURS OR 6 MONTHS
A: ADJUST
C: CLEAN
I: INSPECT
L: LUBRICATE
R: REPLACE
T: PROCEED WITH TASK
EVERY 100 HOURS OR 1 YEAR
PART/TASK LEGEND
GENERAL
Lubrication/corrosion protection (1) T (1) Every 10 hours in salt water use.
ENGINE
Support and rubber mount I I
Exhaust system fasteners (5)
I I
RAVE valve (if so equipped) (5) C C
Counterbalance shaft oil level (if so equipped)
I I
Spark plug (4)(5) I R
Ignition timing (5)
I
Air intake silencer fit/tightness I I
(4) Replace at 150 hours or after 2 years,
whichever comes first.
(5) Emission-related component.
COOLING SYSTEM
Flushing T(3)
Hose and fasteners I I
Engine drain tubes I(1)
Water flow regulator valve (if so equipped)
I
(1) Every 10 hours in salt water use.
(3) Daily flushing in salt water or foul water use.
FUEL SYSTEM
Throttle/choke cables (carburetor equipped models) (1)
I,A,L
Fuel filter (except RFI models) I I R
Fuel injection system sensor (except throttle body) (RFI models)
I I
Fuel lines, connections (RFI), check-valve, relief valve and fuel system
pressurization (5)
I I
Carburetor/throttle body (RFI), fuel rail and fittings (if so equipped) (5) I I
Fuel tank straps I I
(1)Insaltwateruse.
(5) Emission-related component.
LUBRICATION SYSTEM
Oil injection pump (5) I I
Oil lines I I
Oil filter I I R
Oil reservoir straps I
(5) Emission-related component.
smr2005-042 3
www.SeaDooManuals.net

Table of Contents

Related product manuals