Section01MAINTENANCE
Subsection 03 (STORAGE PROCEDURES)
F17E01A
1
1. Engine water outlet hose
Disconnect the engine water inlet hose.
smr05-044-001_a
717 ENGINES
1. Disconnect engine water inlet hose
Temporarily install a short piece of hose to engine
water inlet at cylinder head.
Insert a funnel into hose and pour antifreeze in
engine until the colored solution appears at the
cooling system bleed outlet.
Remove temporary hose and reconnect engine
water inlet hose.
Remove remaining hose pinchers.
Most of the antifreeze will drain out when remov-
ing the hose pinchers. Use a container to recover
it. DISPOSE ANTIFREEZE AS PER YOUR LOCAL
LAWS AND REGULATIONS.
NOTE: Although antifreeze will mainly drain out,
the antifreeze has mixed with the water that was
possibly trapped in the water jackets and thus pre-
venting freezing problems.
At preseason preparation, drain the remaining an-
tifreeze from cooling system prior to using the wa-
tercraft. Ensure no hose pincher was forgotten at
storage.
GTI Models-Equipped with 787 RFI Engines
Some hoses have to be plugged to prevent drain-
ing, before filling cooling system jackets with the
antifreeze.
NOTE: Before beginning the procedure, make
sure the hose is properly connected to the mag-
neto cover.
F17E0AB
1
1. Fitting properly connected
Install a small hose pincher (P/N 295 000 076) on
engine drain hose.
smr2005-044 13
To Next Page
Loading...
Need help?
General
