To Next Page

To Previous Page

Section 01 MAINTENANCE

Subsection 03 (STORAGE PROCEDURES)

smr2005-044-003_A

1. Water supply hose

Install a temporary hose on the engine fitting. To

avoid hose bending, remove the storage tray and

insert the hose by this opening.

smr2005-044-004

Insert a funnel into the temporary hose and pour

antifreeze in engine until the colored solution ap-

pears at the cooling system bleed outlet. Use a

container to recover the water/antifreeze.

F22L0HA

COOLING SYSTEM BLEED OUTLET

1. Recover water/antifreeze from this outlet

Place a container at rear of watercraft to recov-

er the water/antifreeze from the vehicle hose

adapter.

Remove the 2 small hose pinchers from the en-

gine drain hoses.

Most of the antifreeze will drain out when remov-

ing the hose pinchers. Use a container to recover

it. DISPOSE ANTIFREEZE AS PER YOUR LOCAL

LAWS AND REGULATIONS.

Install the water supply hose and remove the large

hose pincher.

To protect the exhaust parts, do the following.

Disconnect the anti-rollover bypass hose from the

calibrated elbow on the tuned pipe water jacket.

smr2005-044-006_A

1. Calibrated elbow

2. Air intake silencer

3. Tuned pipe

16 smr2005-044

SeaDoo 3D User Manual

Questions and Answers: