Motor parameter group 05
PARAMETER DESCRIPTION 142
Measuring
succeed?
If succeed, the operation
panel will display
TEnd.
The motor parameter
auto-tuning is finished
Finish
Manually adjust
parameter values
Offset angle of
PM auto-tuning
Y
0
8
N
Y
N
Y
Measuring
sucdeed?
Y
N
If failed, the
operation panel
display FAL.
N
If succeed, the
operation panel will
display TEnd.
Confirm the wiring
Please refer to 3.7
Terminal wire arrangement)
05-00P.301）
Press the forward/reverse rotation key
and start to measure,
the operation
panel
will display
TUN.
3s
Restore display
after
If failed,the
operation panel
display
FAL.
PM motor manually input
parameters (05-12(P.313)~
05-16(P.307)), and then reset
the inverter.
05-00(P.301)=9, 00-
21(P.300)=5; set the
correct value of 09-
01(P.350) and 09-02(P.351).
Press the forward/reverse
rotation key and start to
measure.
3s
Restore display
after
Set motor parameter
05-01~05-06
Set motor parameter
05-01P.302）~05-06
P.307）
If need induction motor high accuracy sensorless control, set 05-00(P.301) to 3 for sensorless vector control.
Note: 1. Motor capacity must be the same level or one level lower than inverter capacity.
2. Induction motor automatic measurement: if motor can run freely, set 05-00(P.301) to 1. Load has to be
separated from the motor so the motor can turn freely. If the environment does not permit free run, set
05-00(P.301) to 2.
3. Induction motor sensorless vector control: automatic measurement function can be used to enhance the
control function. Before setting 05-00(P.301) to 3, set the motor parameters first and then do automatic
measurement function to improve the control accuracy.
4. When set 05-00(P.301) to 1 (VF + PG), please make sure motor poles 05-02 is correct
To Next Page
Loading...
Need help?
General
