Rapidlab 1200 Operator’s Guide: File Management 7-3
02087462 Rev. V
Copying Patient, QC, or Calibration Data Files
1. Select Recall > Copy Stored Results.
NOTE: The system displays the date for the last time you copied data to the
left of the buttons.
2. Select the type of data you want to copy,
Patient, QC, or Calibrations.
3. Select the type of data storage you are using,
CD or diskette.
4. Insert the diskette or CD into the appropriate drive:
5. Store the diskettes or CD in a safe place, away from heat and strong magnetic
sources such as centrifuges.
Copying Diagnostic Data
Use this procedure to copy diagnostic data to a diskette, CD, or to a remote site
using a network connection. To copy data through a network connection you must
configure your system for a network, and connect it to a device that provides
access to the remote site.
The system stores data for each day including the current day and the previous 29
days.
1. Select Recall > Copy Stored Results > System Data.
2. Select the data or log information to copy.
If you selected... Then...
Diskette, The number of diskettes required is displayed on the screen.
a. When prompted, remove the diskette from the drive and
insert the next diskette in the sequence.
b. Select
Continue.
c. Continue removing and inserting diskettes, as prompted.
d. When prompted, remove the last diskette from the drive and
select
Continue.
CD,
a. When prompted, insert the CD into the drive and select
Continue.
b. When prompted, remove the CD from the drive and select
Continue.
To copy... Then...
wash cartridge information, select
Wash.
reagent cartridge information, select
Reagent.
AutomaticQC cartridge information, select
AQC.
summary data for the database, select
Summary.
data for a single day, select the date.
log information for a single day, select the date and then select
Logs Only.
To Next Page
Loading...
Need help?
General
