02087462 Rev. V
8 System Configuration
Use this section to modify the system configuration options on the Setup menu.
The Setup menu contains the options for customizing the analysis and reporting
characteristics of your Rapidlab
1200 system.
After you customize any of these settings you can select another Setup option or
save the setup data. Refer to
Saving and Restoring System Setup Data‚ page 8-41.
To access the Setup screen, perform the following steps:
1. At the user interface, select Status > Setup.
You can select a setup button on the left of the screen to display the setup
options to configure that system function.
2. Select the function type on the left of the screen.
3. Select the function option on the right side of the screen.
4. Enter your password, if necessary.
Refer to Using Basic System Functions‚ page 2-1.
5. Perform the task according to the instructions in this section.
6. Save the Setup data to a diskette or CD each time you change system
configuration.
Refer to Saving and Restoring System Setup Data‚ page 8-41.
Using the Setup Menu
The following table lists the Setup options and identifies the buttons on the Setup
menu that you select to access each option.
If you want to... Select...
setup QC ranges, schedule, AutomaticQC, and High G/L,
QC
enter ranges, patient or sample demographic information, allow
parameter selection at the Analysis screen, select sample type,
Sample
enable or disable parameters, set up units of measure, demographic
units,
Parameters
select the language and the date format, adjust the sound, and enter a
system name,
System
Options
setup the printer settings, configure the barcode information, or turn
on communications to a data management system or LIS,
Printer and
Devices
set security, setup system analysis functions, backup and restore setup
configuration, and install software upgrades,
Secured
Options
To Next Page
Loading...
Need help?
General
