Siemens Rapidlab 1200 - Default and Alternate Units of Measure

8-16 Rapidlab 1200 Operator’s Guide: System Configuration
02087462 Rev. V
Default and Alternate Units of Measure
This table lists the parameters the system can report and the default and alternate units of
measure for each parameter.
Parameter Default Units Alternate Units
pH (pH units) nmol/L
When selecting alternate units, the parameter name
changes to H
+
.
pCO
2
mmHg kPa
pO
2
mmHg kPa
Na
+*
mmol/L
K
+*
mmol/L
Ca
++*
mmol/L mg/dL
Cl¯
*
mmol/L
Glu
*
mg/dL mmol/L
Lac
*
mmol/L mg/dL
tHb
†
g/dL g/L, mmol/L
FO
2
Hb
†
% (decimal)
FCOHb
†
% (decimal)
FMetHb
†
% (decimal)
FHHb
†
% (decimal)
pH(T) (pH units) nmol/L
When selecting alternate units, the parameter name
changes to H
+
(T).
pCO
2
(T) mmHg kPa
pO
2
(T) mmHg kPa
HCO
3
¯act mmol/L
HCO3¯std mmol/L
BE(B) mmol/L
BE(ecf) mmol/L
ctCO
2
mmol/L
Ca
++
(7.4)
mmol/L mg/dL
sO
2
†
% (decimal)
O
2
SAT(est) % (decimal)
O
2
CT mL/dL mL/L, mmol/L