Rapidlab 1200 Operator’s Guide: System Configuration 8-9
02087462 Rev. V
Setting up Patient Demographics or Sample
Demographics
At the Patient Demographics or Sample Demographics screen you can select the
following options:
• Required entries
Use this option to set up the demographic fields to use at the Data Entry
screen.
• Rapid Sample Identification
Select this option to allow the system to use the patient ID to search for
matching patient information in remote databases such as Rapidlink,
Rapidcomm, or an LIS.
• Default value for the century entered for the date of birth
• Allow alphanumeric characters for use in the Patient ID field
Using Patient and Sample Demographics
The following table lists the patient and sample demographics that you can select.
When you enter a patient ID for an existing patient, the system populates the
patient data from stored patient information. When you modify patient
information, the system updates this information in all samples that use this
patient ID.
NOTE: If you turn off a sample demographic that is necessary to determine
results, the system also turns off any parameters that require that sample
demographic. To identify the demographics needed to report results, refer to
Setting up Parameters‚ page 8-13.
Patient Demographics Sample Demographics
Patient ID Location
Last Name Physician ID
First Name Draw Date
Sex Draw Time
Date of Birth Accession No.
Operator ID
Temperature
tHb
F
I
O
2
Flow
Resp. Rate
To Next Page
Loading...
Need help?
General
