Rapidlab 1200 Operator’s Guide: System Configuration 8-29
02087462 Rev. V
Entering IP Addresses
Use this procedure to enter network IP addresses.
1. Obtain the following network information from your institution’s network
administrator:
• IP address for the Rapidlab 1200 system
• IP address for the Rapidlink or Rapidcomm server or workstation where
you want to connect the Rapidlab 1200 system
• IP address for the default router port assigned to the network segment on
which the Rapidlab 1200 system is located
• Network mask for the institution’s network
2. Select the communication settings at the Rapidlab 1200 system:
a. At the Setup screen, select
Printer and Devices > Communications.
b. Select
CompleNet > Configure.
c. Select
Save.
d. Select
Enter IP Address.
e. Enter the IP addresses for the Rapidlab 1200 system, the default router
port, and the network mask.
Ensure that you enter the IP addresses and the network mask in the correct
fields.
f. Select
Save.
3. At the Communications screen, select
Save.
4. When prompted that the connection was unsuccessful, select
Continue.
5. Connect the network cable to the RJ-45 connector on the back panel of the
Rapidlab 1200 system.
6. Connect the network cable to the site network connection.
7. At the Rapidlink or Rapidcomm workstation, enter the communication
settings.
Refer to the Rapidlink Supervisor’s Manual or Rapidcomm User’s Guide.
8. At the Rapidlab 1200 system, select
Save.
9. Select
Return when finished.
10. To complete any additional setup that may be necessary to operate the
Rapidlab 1200 system with the Rapidlink or Rapidcomm program, refer to the
Rapidlink Supervisor’s Manual or Rapidcomm User’s Guide.
To Next Page
Loading...
