Siemens Rapidlab 1200 - Defining Operator Ids and Passwords

Rapidlab 1200 Operator’s Guide: System Configuration 8-37
02087462 Rev. V
The Unrestricted access setting allows for more access with fewer password
requirements on every level.
Defining Operator IDs and Passwords
You can enter, edit, or delete operator IDs and passwords and specify the level of
access for each operator. Refer to the tables in
Setting up Operator Security
Levels‚ page 8-35.
If your Rapidlab 1200 system is connected to a data management system, you can
turn on the option to notify operators when their password is about to expire. The
message is displayed 14 days before the password expires.
The default operator ID and password is 12345, with Level 1 access. Define at
least 1 operator with Level 1 access and then delete the default operator ID. You
can enter information for up to 5000 operators. Ensure at least one Level 1
operator is entered in the operator list when you download operators to the system
NOTE: Instrument screen transition time into and out of instrument Setup may be
slow while the analyzer is processing the new list, if the operator list downloaded
to the system is large or a large preexisting operator list is modified in instrument
setup.
1. At the Setup screen, select
Secured Options > Operator Security.
Each operator ID and password combination must be unique.
Table 8-3 Unrestricted Access Setting
Level/Pass Level/Pass Level/Pass Level/Pass
Function 1234
analyzing samples Yes/No Yes/No Yes/No Yes/No
recalling data Yes/No Yes/No Yes/No Yes/No
replacing cartridges Yes/No Yes/No Yes/No Yes/No
initiating calibrations Yes/No Yes/No Yes/Yes Yes/Yes
accessing Setup
options
Yes/No Yes/No Yes/No Yes/No
accessing Diagnostics Yes/Yes Yes/Yes No No
accessing the Restore
QC screen
Yes/Yes Yes/Yes Yes/Yes No
accessing secured
options
Yes/Yes No No No