2-32 Rapidlab 1200 Operator’s Guide: Operating the System
02087462 Rev. V
Printing Reports on the External Printer
For reports printed on the external printer, the system formats the report with
approximately a 1-inch margin from each edge of the 8-1/2 X 11-inch page or A4 paper.
When a report runs to multiple pages, the following rules apply:
• The system identifiers are only on the first page.
• Page breaks occur when the printing reaches the end of the page.
• The report does not display any headers, footers, or page numbers.
Using Available Reports
The system offers the following reports:
Report Name Description
Arterial-Venous Study Report Provides an a-v study report.
Only available on Rapidlab 1245 and
1265 systems.
Refer to Combining Results for an a-v
Study Report‚ page 2-35.
QC Sample Report Provides a report of QC results performed
or recalled.
Refer to Recalling QC Results‚ page 4-7.
QC Report, High G/L Provides a report of the High G/L test.
Refer to Analyzing High G/L‚ page 5-3.
AutomaticQC Report Prints a report of an AutomaticQC sample,
performed or recalled.
Refer to Using the AutomaticQC Analysis
Option‚ page 4-3.
Calibration Report–Full Report Prints a report for calibrations if you
selected Full in Setup.
Full means with measurement results and
drifts.
Refer to Selecting Printer Options‚
page 8-22, and Generating Calibration
Reports‚ page 3-3.
Calibration Report–System Status Report Prints a report for calibrations if you
selected Status in Setup.
Status means a summary of parameter
calibration pass or fail states.
Refer to Selecting Printer Options‚
page 8-22 and Generating Calibration
Reports‚ page 3-3.
To Next Page
Loading...
