Rapidlab 1200 Operator’s Guide: System Configuration 8-39
02087462 Rev. V
Selecting Demographics Editing
The edit demographics option allows you to edit patient and sample demographics
for patient samples that are already saved. When you use this option, you can edit
demographics for individual patient samples when you recall the sample results.
If you edit a patient’s demographics and then print the patient sample report, a
me
ssage on the report indicates that the data was edited. If your system is
connected to a Rapidlink or Rapidcomm data management system, or an LIS, the
Rapidlab 1200 system also sends the edited sample data to the computer system.
1. At the Setup screen, select
Secured Options > Analysis Options.
2. Select
Edit Demographics and then select Save.
Displaying Question Result
Use this option to show results that are flagged as question results. Calibration
verification material sometimes produces results that are displayed as question
results (-----?).
When you turn on this option, the
system shows these results, for tHb and the
fractions, with a question mark (?) instead of displaying no results (-----?).
CAUTION: Do not perform analysis during proficiency testing. When this option
is turned on, results for patient samples are not reliable. Turn the option off when
testing is completed.
Use the Display Question Results option with Rapidlab 1245 and 1265 systems to
display the results for
tHb and fractions when performing proficiency testing.
To set up Display Question Result,
perform the following steps:
1. At the Setup screen, select
Secured Options > Analysis Options.
2. Select
Display Question Result and then select Save.
3. Select
Return.
4. Perform proficiency testing.
5. After proficiency testing, repeat Steps 1 and 2 to turn the Display Question
Results option off.
To Next Page
Loading...
