Siemens Rapidlab 1200 - Setting up Printer and Devices Options; Selecting Printer Options

8-22 Rapidlab 1200 Operator’s Guide: System Configuration
02087462 Rev. V
Setting up Printer and Devices Options
When you select Printer and Devices at the Setup Window, the following options are
available:
• Printer Options
•Barcode Setup
• Communications
Selecting Printer Options
The Setup–Printer Options screens allow you to perform the following functions:
• enable or disable the internal and external printer
• select the number of copies for patient and QC sample reports
• select printer settings for each type of reports
The Setup–Printer Options screen displays options based on the selected report. Select
several different reports to view the available options.
To set up printer options, perform the following steps:
1. At the Setup screen, select Printer and Devices > Printer Options.
2. At the Printer Options screen, select the report type from the scrollable list.
The system displays only those options that are available for that report.
3. Select the printer that you want to print this report,
Internal Printer or External
Printer
.
To print this report on both printers, complete these steps for one printer then select
the other printer.
4. Select
Use.
5. Select
Auto Print, if it is available.
When you select Auto Print, the system automatically generates the report when it
completes the analysis.
6. Select the number of copies to print:
1, 2, or 3.
The default number of copies is 1. If this selection is not available, the system prints
only one copy.