Siemens Rapidlab 1200 - Page 339

Rapidlab 1200 Operator’s Guide: System Configuration 8-45
02087462 Rev. V
To set up maintenance tasks on your system, perform the following steps:
1. At the Setup screen, select Secured Options.
2. Select the down arrow button and then select
Maintenance.
3. Select
Setup Schedule.
4. At the Setup Maintenance screen, select and perform the following tasks as
necessary:
For this task... Then...
Add a maintenance task,
a. Select
Add.
b. Enter a Description.
c. Edit the Frequency.
d. Edit the Task Due On.
e. Select
Save.
Edit the frequency of a
predefined or user
defined maintenance
task,
a. Select a task.
b. Select
Edit.
NOTE: You cannot decrease the frequency of a predefined
task. You can only increase it. You cannot edit the name of a
predefined task.
c. Select
Frequency.
d. Select the frequency.
The system displays screens for selecting a time period
or set of times appropriate to your selection.
e. Select
Save.
The Save button is not available until you make all the
necessary selections.
Delete a user defined
maintenance task,
a. Select a task.
b. Select
Delete.
NOTE: User defined maintenance tasks are the only tasks
you may delete. When you select a predefined maintenance
task, the Delete button is disabled.
c. Select
Yes.
Enable and disable
maintenance tasks,
a. Select a task.
b. Select
Edit.
c. Select
Enable.
View maintenance task
details,
select
Details.