Routes ECDIS-E User Guide
8-6 65934012
Add Waypoint
Add Waypoint is selected where the insertion of a new waypoint is to be
made after the last waypoint. e.g. if the last waypoint on the route was
WPT5 then the appended waypoint will be WPT6.
To add a waypoint to a route, do the following:
1. Select Add Waypoint from the semi transparent window. The
screen shows a coloured circle at the cursor point when the
waypoint selection was made. To view the waypoint
Latitude/Longitude position select the waypoint and click on the
Edit Routes Waypoints tab, see Editing a Route.
2. To add an additional waypoint, position the cursor at the required
point and select Add Waypoint again. An additional waypoint is
created.
When two or more waypoints are created a straight route leg is drawn
between each waypoint.
When three or more waypoints are created the system displays the turn
radius at each waypoint (except first and last) using the system default
radius, or a radius value modified by the user, see Editing a Route.
Add Waypoint to Beginning
Add Waypoint to Beginning is selected where the insertion of a new
waypoint is to be numbered before the first waypoint in the route e.g. the
new waypoint becomes WPT1 and all other waypoint references are
moved up one digit accordingly.
To add a waypoint to the beginning of a route, do the following:
1. Select Add Waypoint to Beginning from the window. The screen
shows a coloured circle at the cursor point when the waypoint
selection was made. To view the waypoint details click on the Edit
Routes Waypoints tab, see Editing a Route
2. To add another waypoint before the first waypoint, position the
cursor at the required point and select Add Waypoint to
Beginning again. The new waypoint becomes
WPT1 and the first
waypoint changes to
WPT2.
To Next Page
Loading...
