STC8A8K64D4 Series Manual
-
ERXI: I
2
C slave completes receiving data event interrupt request flag, which must be cleared by software.
ETXI: I
2
C slave completes transmitting data event interrupt request flag, which must be cleared by software.
ESTOI: I
2
C slave receives the STOP event interrupt request flag, which should be must by software.
Enhanced PWM Configuration Register
PWMCBIF: Enhanced PWM0 counter interrupt request flag, which must be cleared by software.
Enhanced PWM Interrupt Flag Register
C7IF: Enhanced PWM channel 7 interrupt request flag, which must be cleared by software.
C6IF: Enhanced PWM channel 6 interrupt request flag, which must be cleared by software.
C5IF: Enhanced PWM channel 5 interrupt request flag, which must be cleared by software.
C4IF: Enhanced PWM channel 4 interrupt request flag, which must be cleared by software.
C3IF: Enhanced PWM channel 3 interrupt request flag, which must be cleared by software.
C2IF: Enhanced PWM channel 2 interrupt request flag, which must be cleared by software.
C1IF: Enhanced PWM channel 1 interrupt request flag, which must be cleared by software.
C0IF: Enhanced PWM channel 0 interrupt request flag, which must be cleared by software.
Enhanced PWM Abnormal Detection Control Register
FDIF: Enhanced PWM abnormal detection interrupt request flag, which must be cleared by software.
Port interrupt flag registers
PnINTF.x: Port interrupt request flag (n=0~7, x=0~7)
0: No interrupt request for Pn.x port
1: Pn.x port has an interrupt request, if the interrupt is enabled, it will enter the interrupt service routine. The flag bit
needs to be cleared by software.
LCM Interface Status Register
LCMIFIF: LCM
interface interrupt request flag. Need to be cleared by software.
DMA interrupt flag registers
To Next Page
Loading...