STC micro STC8A8K64D4 Series - INT1 Interrupt (Rising and Falling Edges)

STC8A8K64D4 Series Manual
-
- 223 -
ORG 0000H
LJMP MAIN
ORG 0003H
LJMP INT0ISR
ORG 0100H
INT0ISR:
CPL P1.0 ;Test port
RETI
MAIN:
MOV SP, #5FH
MOV P0M0, #00H
MOV P0M1, #00H
MOV P1M0, #00H
MOV P1M1, #00H
MOV P2M0, #00H
MOV P2M1, #00H
MOV P3M0, #00H
MOV P3M1, #00H
MOV P4M0, #00H
MOV P4M1, #00H
MOV P5M0, #00H
MOV P5M1, #00H
SETB IT0 ;Enable INT0 falling edge interrupt
SETB EX0 ;Enable INT0 interrupt
SETB EA
JMP $
END
11.5.3 INT1 Interrupt (Rising and Falling Edges)
C language code
//Operating frequency for test is 11.0592MHz
#include "reg51.h"
#include "intrins.h"
sfr P0M1 = 0x93;
sfr P0M0 = 0x94;
sfr P1M1 = 0x91;
sfr P1M0 = 0x92;
sfr P2M1 = 0x95;
sfr P2M0 = 0x96;
sfr P3M1 = 0xb1;
sfr P3M0 = 0xb2;
sfr P4M1 = 0xb3;
sfr P4M0 = 0xb4;
sfr P5M1 = 0xc9;
sfr P5M0 = 0xca;
sbit P10 = P1^0;
sbit P11 = P1^1;
void INT1_Isr() interrupt 2
{