STC8A8K64D4 Series Manual
-
P7 Interrupt mode register 1
I/O port interrupt priority low
register
I/O port interrupt priority high
register
P0 interrupt wake-up enable
register
P1 interrupt wake-up enable
register
P2 interrupt wake-up enable
register
P3 interrupt wake-up enable
register
P4 interrupt wake-up enable
register
P5 interrupt wake-up enable
register
P6 interrupt wake-up enable
register
P7 interrupt wake-up enable
register
12.1.1 Port interrupt enable registers (PxINTE)
PnINTE.x: Port interrupt enable control bit (n=0~7, x=0~7)
0: disable Pn.x port interrupt function
1: Enable Pn.x port interrupt function
12.1.2 Port interrupt flag registers (PxINTF)
PnINTF.x: Port interrupt request flag (n=0~7, x=0~7)
0: No interrupt request for Pn.x port
1: Pn.x port has an interrupt request, if the interrupt is enabled, it will enter the interrupt service routine. The flag
bit needs to be cleared by software.
To Next Page
Loading...