Stoll CMS ADF-3 - Page 10

10
8 Software - Installation and basic settings 365
8.1 Boot process ........................................................................................................................ 366
8.1.1 Basic Settings........................................................................................................... 370
8.2 Saving all machine data on the USB-Memory-Stick ............................................................ 381
8.3 Saving pattern after a big fault ............................................................................................. 382
8.4 Installing the Stoll operating system .................................................................................... 385
8.4.1 Direct installation ...................................................................................................... 386
8.4.2 Indirect installation.................................................................................................... 392
8.4.3 Updating software .................................................................................................... 398
8.4.4 Carrying out a restart (Restart)................................................................................. 402
8.4.5 Carrying out restart with machine configuration (Restart and Configuration)........... 403
8.4.6 Setting online connection ......................................................................................... 405
8.4.7 Overview of all system data...................................................................................... 407
8.5 Diagnose Control ................................................................................................................. 408
9 Yarns and stitch tension 411
9.1 Economic production and the influencing factors ................................................................ 411
9.2 Stitch Tension Range .......................................................................................................... 413
9.3 Stitch lengths ....................................................................................................................... 414
9.4 Yarn table ............................................................................................................................ 417
9.5 Conversion table .................................................................................................................. 420
10 Machine Management Tools 421
10.1 Machine Management Tools window .................................................................................. 421
10.2 Display the virtual keyboard ................................................................................................. 423
10.3 Remote control with the software VNC ................................................................................ 424
10.3.1 Activating the remote control VNC on the machine.................................................. 425
10.3.2 Configuring the remote control VNC on the machine............................................... 426
10.3.3 Determine the IP address of the machine ................................................................ 427
10.3.4 Installing software VNC Viewer on the computer (e.g. a note-book)........................ 427
10.3.5 Remote control with the VNC Viewer ....................................................................... 428
10.3.6 Remote control via a web browser ........................................................................... 430
10.4 Send email directly from the machine .................................................................................. 432
11 Key word directory 437