385
8 Software - Installation and basic settings
8.4 Installing the Stoll operating system
8.4 Installing the Stoll operating system
The Stoll operating system can be installed in two ways:
Direct Installation:
After switching on the main switch, the "BootOkc" window gets
displayed. Type in within the waiting time for the warm start on the
"Basic Settings" key, and select the memory location of the new Stoll
operating system in the "Basic Settings Menu" window. Go back to the
"BootOkc" window, and type on the "Installation" key or "Installation and
Configuration". The installation process is triggered.
When you tap on the "Installation" key, the installation is run through till
the "Reference run" window.
When you tap on the "Installation and Configuration" key, the machine
can be configured afresh for stopping the installation.
Indirect Installation:
During the production the new Stoll operating system is copied on the
hard disk. You use the "Updating software" window for this purpose.
When the machine is switched on again the software can determine that
a new Stoll operating system is available for installation. You will be
asked in one window whether you want to install the new Stoll operating
system and whether you wish to configure the machine anew
simultaneously. If you acknowledge this process with "Yes" the
installation process gets started with or without configuration.
In the next sections the different types of installations will be discussed at
length.
Direct installation [-> 386]
Indirect installation [-> 392]
Updating software [-> 398]
Carrying out a restart (Restart) [-> 402]
Carrying out restart with machine configuration (Restart and
Configuration) [-> 403]
Setting online connection [-> 405]
Overview of all system data [-> 407]
Setting touch screen [-> 67]
Setting machine parameters [-> 154]
Basic Settings [-> 370]
To Next Page
Loading...
