Stoll CMS ADF-3 - Putting up Bobbins; Threading Threads through Yarn Guide Bracket; Threading Threads through Yarn Control Device

71
3 Producing with the knitting machine
3.2 Threading up yarn
3.2.2 Putting up bobbins
When the threads of several bobbins are led to one yarn carrier, supply
approximately the same number of threads to the yarn carrier from each
side.
➜ Put up the bobbins on the knitting machine or on the additional bobbin
board.
3.2.3 Threading threads through yarn guide bracket
1. Push the yarn guide brackets to the side so that a yarn guide bracket
hangs over each bobbin.
2. Thread each thread through a yarn guide bracket.
3.2.4 Threading threads through yarn control device

Path of the thread through the yarn control device
1. Remove the tension arm from the stay.
For this pull the tension arm somewhat to the front.
2. Thread each thread through a yarn control device as shown in the
picture.