Stoll CMS ADF-3 - Yarn Length

Setup Data 5
Setup2 Editor 5.4
258
5.4.7 Yarn length
Basic settings
Further information:
 Helpers for Input [-> 239]
 File tools [-> 245]
 Table Tools [-> 244]
 Setup Data [-> 233]
 Overview of the Setup2 Editor of the CMS [-> 237]
 Comparing Setup1 to Setup2 [-> 235]
Explanation
"Operating
mode for
patterns"
Determine the yarn length control mode.
: On the CMS the mode can be changed here.
 Production without YLC
 Working with mm
 Working with original fabric
 According to Sintral specification
"Correction data
(Working with
mm)"
No correction data was determined yet.
Correction data was determined.
"Original fabric
data (Working
with original
fabric)"
"Wheel" left device: Select measuring wheel (n=9 to 16).
right device: Select measuring wheel (n=1 to 8).
"Y" Select the yarn carrier (1A to 8D) working with this measuring
wheel.
"Comment" Comment (ASCII Characters)