279
6 Maintenance of the knitting machine
6.2 Cleaning the knitting machine
6.2.5 Cleaning thread clamping and cutting device
Cleaning thread clamping and cutting device
1. Push the clamping and cutting needle upward.
2. Clean the clamp and cutting needles and the clamping pinion with a
cloth or a brush.
3. Push the clamping and cutting needle back upward.
6.2.6 Cleaning the friction feed wheel *
Cleaning the friction feed wheel
1. Suck in the fluff and dust from the friction feed wheel.
2. Remove dirt (e. g. paraffin) from the friction rollers.
Further information:
Symbols in this document [-> 14]
To Next Page
Loading...
