Stoll CMS ADF-3 - Repairing the Knitting Machine; Supplementary Activities During Maintenance; Switching Power Supply 40 V off and on

297
7 Repairing the knitting machine
7.1 Supplementary activities during maintenance
7 Repairing the knitting machine
This chapter contains information on:
 Supplementary activities during maintenance [-> 297]
 Helpful knitting rows [-> 303]
 Replacing parts [-> 305]
 Eliminating faults in electronics system [-> 345]
 Needle selection displacement [-> 354]
 Entering the data of the needle selection displacement manually [->
360]
7.1 Supplementary activities during
maintenance
This chapter contains information on:
 Switching power supply 40 V off and on [-> 297]
 Moving yarn carriers and repositioning them [-> 299]
 Separating the suction tubes from the carriage [-> 300]
 Move the carriage assembly outward up to the support surface [-> 301]
 Sliding board [-> 302]
7.1.1 Switching power supply 40 V off and on
The power supply of the carriage (step motors, selection systems, yarn
carrier plunger) can be switched off for assembling works. This eliminates
the switching off and on of the main machine switch and thereby the waiting
time until the computer of the knitting machine has shut down and rebooted.
The machine cannot be started with the engaging rod when the power
supply is switched off.
Key Function
Call up the "Service" menu
Call up window "Manual interventions Service"
Confirm message
Keys for switching power supply 40 V off / on