Stoll CMS ADF-3 - Lubrication Interval

Maintenance of the knitting machine 6
Lubricate knitting machine 6.3
286
6.3.1 Lubrication interval
To retain the operability of the knitting machine and ensure the quality of the
fabric, the knitting machine must regularly be lubricated.
Lubricants Use only the lubricants found with the accessories of the machine or those
listed in the lubricating schedule.
Lubrication interval Lubricating work
adjustable
Recommendation: Every 6
- 10 operating hours; select
shorter interval if
necessary
Oiling the needle bed
10 operating hours Oiling the jack bed
Oiling the control of the holding-down jacks
Oiling the wires in the yarn carrier rails
100 operating hours Greasing the impulse sensor rails
Greasing the coupling parts and the intermediate
sliders
1 month Greasing the yarn carrier bows
2 months Greasing the linear guidance of the carriage
6 months Greasing the racking device
Greasing the needle bed supports/adjustment pieces
Lubrication schedule
Only the named lubricants or others recommended by Stoll
may be used. Other lubricants may damage the machine, e.
g. due to insufficient lubricating action, rust on metal parts or
damage to the electrical cable insulation and the plastic
parts. We point out here that failure to observe this, will void
our warranty services.
Label Gauge ID
Oil Silvertex T46
E3 │ E3,5 │E4│E5│E7│E8
│ E2,5.2 │ E3,5.2 │ E5.2 │E10│E12
│E14│E6.2 │ E7.2
230 614
Silvertex T32
E16 │ E18 │ E8.2 │ E9.2
005 341
Grease OKS 475 005 351
Klueber Staburags
NBU 12/300 KP
231 191
In the first weeks after setting up the knitting machine, select
shorter lubricating intervals.