Adjusting knitting machine 4
Advanced adjustments 4.2
172
4.2.13 Adjusting needle detector
The needle detector is correctly adjusted if:
Adjusting the needle detector
it is near the holding-down jacks of the rear needle bed, however does
not tap them
the lower end of the needle detector is at the level of the needle hooks
➜ Staggering yarn carriers.
Further information:
Staggering yarn carriers [-> 114]
IMPORTANT
Damage to the needle detector!
If several yarn carriers are stopped at the same place, the
needle detector will be damaged, as the yarn carriers cannot
avoid the needle detector.
➜ Always stagger yarn carriers.
To Next Page
Loading...
