129
4 Adjusting knitting machine
4.1 Basic settings
4.1.13 Setting value for releasing thread clamp
The thread clamping and cutting device holds the thread of a yarn carrier
not used for knitting at the moment. When the yarn carrier is used again, the
carriage opens the clamping device after knitting a few rows and the yarn
end is released. The clamp is released after 19 knitting rows as standard.
This value can be set individually for each yarn carrier in the "Release
clamps" window.
"Release clamps" window
Setting value for releasing thread clamp:
1. Call up the "Release clamps" window from the "Main menu".
2. Tap the input field of the corresponding yarn carrier and enter a value.
In the default setting the value "20" which corresponds to 19 knitting
rows (value - 1) is set.
3. Confirm entries.
4. Call up "Main menu".
Key Function
Call up "Release clamps" window
Confirm entries
Call up "Main menu"
Keys for entering the value for releasing thread clamp
To Next Page
Loading...
