Stoll CMS ADF-3 - Restarting Lubricating Interval; Oiling Jack Bed; Oiling the Control of the Holding-Down Jacks

289
6 Maintenance of the knitting machine
6.3 Lubricate knitting machine
6.3.4 Restarting lubricating interval
1. Tap display for "Lubricate needle bed" message.
 The "Current message" window appears.
2. Tap"624 Lubricate needle bed (OIL)" message.
 The message is marked with a frame. The function key for opening
the "Sensors" window appears at the bottom of the touch screen.
3. Call up the "Sensors" window.
4. Input "Syst. run through until lubric.".
5. Confirm input.
6. Call up "Main menu".
6.3.5 Oiling jack bed

Oiling the jack bed
➜ Use a brush to apply oil to the jack bed (1).
6.3.6 Oiling the control of the holding-down jacks
➜ Apply oil on the control of the holding-down jacks with a brush.
IMPORTANT
If a spray gun is used for oiling, too much oil may be
applied!
The suction tube becomes clogged.
➜ Do not use a spray gun for oiling.