Machine Management Tools 10
Remote control with the software VNC 10.3
428
10.3.5 Remote control with the VNC Viewer
1. Start the software VNC Viewer on the computer.
The "VNC Viewer: Connecting Details" window opens.
"VNC Viewer: Connection Details" window
2. Enter the noted IP address of the machine in the "Server" field.
3. In order to configure the software VNC Viewer when needed, click on
the "Options" button.
The "VNC Viewer Options" window opens.
"VNC Viewer Options" window, "Colour & Encoding" tab
4. In order that all colors are displayed, activate the "Full (all available
colours)" option on the "Colour & encoding" tab under "Colour level".
5. In order to make a small square visible as the mouse pointer alternative,
deactivate the "Render cursor locally" check box on the "Misc" tab.
6. To save the option adjustments, click on the "Save" button on the "Load
/ Save" tab under "Defaults".
7. Click on the "OK" button.
When your network makes the Naming Service available,
instead of the IP address the host name can also be entered.
If another port as 5900 was entered during configuration of
the remote control VNC on the machine, the port must be
entered along with e. g. 172.17.12.54:5903.
You can find continuative instructions for configuration of
VNC in the documentation of VNC.
To Next Page
Loading...
