Software - Installation and basic settings 8
Installing the Stoll operating system 8.4
386
8.4.1 Direct installation
For the Direct Installation the installation process is started directly in the
"BootOkc" window.
Overview:
Start the installation process by switching on the machine. In the
"BootOkc" window, tap on the "Basic Settings" key to select memory
location in which the installation data is available (Boot Source).
In the "BootOkc" window, start the installation with the "Installation and
Configuration" or "Installation" keys.
Configure the machine after having selected the "Installation and
Configuration" key or start a reference run after having selected the
"Installation" key.
Select the "Installation and Configuration" key, if along with
the installation of the new Stoll operating system the machine
parameters are also to be altered.
Select the "Installation" key, if the machine parameters are
not to be altered. This shortens the installation process.
The current operating system version will be overwritten!
When you install a new Stoll operating system version the
current one is overwritten.
Carry out the following steps only if you want to replace the
current operating system by the previous version.
Save the machine data and the files specifically the ones you
have created before the installation process.
To Next Page
Loading...
