Stoll CMS ADF-3 - Carriage Speed

Setup Data 5
Setup2 Editor 5.4
256
5.4.5 Carriage speed
Different carriage speeds can be entered for different knitting situations.
The indirect carriage speed only becomes effective when it is slower than
the normal speed.
Further information:
 Table Tools [-> 244]
 Helpers for Input [-> 239]
 Setup2 Editor [-> 237]
 Setup Data [-> 233]
 Comparing Setup1 to Setup2 [-> 235]
 File tools [-> 245]
Explanation Value range
(meters/second)
MSECK Carriage speed for small knots over m rows,
standard: 1 row
Minimum value: 0.05
Maximum value: 1.20
Step width: 0.05
MSEC Speed
(normal speed)
Minimum value: 0.05
Maximum value: 1.20
Step width: 0.05
MSEC0 Speed for empty rows (S0) Minimum value: 0.05
Maximum value: 1.40
Step width: 0.05
MSEC1 Speed for transfer rows Minimum value: 0.05
Maximum value: 1.20
Step width: 0.05
MSECI Speed with Intarsia Yarn Carrier Minimum value: 0.05
Maximum value: 1.00
Step width: 0.05
MSECC Speed outside the needle bed when the yarn
carrier is brought in the clamp or taken out of
the clamp.
Minimum value: 0.05
Maximum value: 0.50
Step width: 0.05
MSEC2-20 Speed for knitting rows Minimum value: 0.05
Maximum value: 1.20
Step width: 0.05
Comment Comment ASCII Characters