259
5 Setup Data
5.4 Setup2 Editor
Correction Values
Explanation
"Correction for
all measuring
wheels"
Enter a correction value for all measuring wheels
"Maximum
deviation of the
target value per
knitting row"
Stopping the machine when exceeding the correction value
(Standard = 15%).
"Wheel" right device: Select measuring wheel (n=1 to 8).
left device: Select measuring wheel (n=9 to 16).
"Y" Select the yarn carrier (1A to 8D) working with this measuring
wheel.
"Correction < +/-
[%]"
Enter correction value for an additional thread from the from the
right.
The correction value has an effect in the carriage direction to the
left.
"Correction > +/-
[%]"
Enter correction value for an additional thread from the from the
left.
The correction value has an effect in the carriage direction to the
right.
Only when "Working with original fabric"
"Yarn correction
for original
fabric"
Change the fabric length without determining once again the
original fabric data. If, for example, the same pattern is to be
knitted with another yarn color (not yarn thickness).
Value range: -10%...+10%, step width: 0.1
To Next Page
Loading...
