315
7 Repairing the knitting machine
7.3 Replacing parts
10. Check whether the edges of the damaged stays have burrs. If this is the
case, carefully remove these burrs with the channel file.
Removing burrs
11. Check whether the needle bed elements move easily in the grooves.
Repeat step 5.
12. If everything is in order, carefully polish the needle bed with the channel
file. Place the channel file flat on the needle bed and lightly move it back
and forth perpendicular to the needle channel.
13. The metal debris must be removed from the needle channels. For this
purpose, clean the area of repair with a brush.
14. If everything is in order, reinsert the moving parts into the needle bed.
Further information:
Removing carriage part [-> 316]
Replacing needle and coupling part [-> 306]
Replacing intermediate slider [-> 307]
Replacing selection jack [-> 309]
IMPORTANT
The needle bed may be damaged if the channel file is
used improperly!
If too much of a stay is filed off, the needle bed is defective at
this point and can only be repaired by a Stoll technician.
➜ Use the channel file for the removal of burrs only.
➜ The grooves must be cleaned carefully after the channel
file is used.
To Next Page
Loading...
