383
8 Software - Installation and basic settings
8.3 Saving pattern after a big fault
Save pattern:
1. If you want to save the logfiles and the pattern, then tap on the "YES"
key.
2. You will be asked where the logfiles and the pattern which has been
loaded recently are to be saved. We recommend to save the pattern on
a USB-Memory-Stick or network drive.
3. Confirm the path specification.
4. The selected files will be saved under a new name.
Saved_pattern.sin (.jac, .set, .setx, .seq)
with a sequence: Saved_pattern1.sin, Saved_pattern2.sin, etc.
5. Once the data are saved, a message is displayed. Confirm this
message with "OK"
6. Carry out the "Restart".
7. Rename files. You cannot carry out this on the knitting machine. For this
purpose go to the M1plus or a PC.
To Next Page
Loading...
