Stoll CMS ADF-3 - Page 393

393
8 Software - Installation and basic settings
8.4 Installing the Stoll operating system
Start installation ✔ The Stoll operating system was updated.
✔ The machine is switched off.
1. Set the main switch to 1.
 The "BootOkc" window is displayed with the following message on
the touch screen:

"User Message" window (START UPDATE NOW?)
2. Deactivate the "Installation without configuration" check box, if the
machine parameters are also to be altered simultaneously with the
installation of the new Stoll operating system.
- or -
➜ Activate the "Installation without configuration" check box, if you do not
want to alter any machine parameters.
3. To start installation process tap on "YES".
 In the "User Message" window (INSTALLATION STARTED!) the
path to the installation data is displayed.

"User Message" window (INSTALLATION STARTED!)
4. If only the files that have got altered are to be installed anew during the
installation deactivate the "FORCE INSTALLATION" check box
(expedites the installation process).
To proceed with the old Stoll operating system, tap on "NO".