6.5.11 Masters
The parameters for the summing (master) outputs are set here. Not all param-
eters are available for all of the masters; the audition output, e.g., only has a
label.
Label This is the string that is displayed in the routing output page. The label may
have up to eight characters. It can be dened as described in chapter 6.5.1.
OnAir Relevant For each of the main master outputs, it is congured here whether it contrib-
utes to the On Air indication or not. The On Air indication is active only if at
least one channel is switched ON, has the its fader open and is assigned to an
active main master. Selections: On / Off.
(Output) Limiter Each of the tree main output buses features a transmission limiter that can be
congured here. Setting: On / Off.
(Outp.) Limiter Threshold (dB
FS
) The output limiter’s threshold can be set in a range of 0...–48 dB
FS
in steps of
1 dB.
Please note that this indication is always referenced to full scale modulation
(FS), regardless of the currently selected headroom – which means that, if
a headroom of 9 dB is set and limiting to 0 dB on the PPM level meters is
desired, a limiter threshold of –9 dB
FS
must be selected.
(Output) Limiter Release Time The output limiter’s release time can be set in 13 steps in a range of 1 ms
(millisecond) to 1 s.
Joker Function Name Basically, all corresponding keys in the fader strip have the same function
throughout the whole console. For this reason, one exception from this rule
may be congured that will then be source- or master-related, i.e., linked to a
particular source or master, and that will also be considered once this master
should be re-routed to a different channel strip. This function key is called
the “Joker” key.
To Next Page
Loading...
