OnAir 2500 Digital Mixing Console
Operation 5-23
Date printed: 18.07.08
SW V3.0
SP SRC “Split mode” - an additional, third signal may be monitored on the DJ phones.
This is selected with the SP SRC rotary encoder and its display.
SP SRC/MON When activating the SP SRC/MON button, this third signal is fed to the
left channel; the standard monitor signal plus the one selected with the Add
function are then mixed to the right channel.
Balance The balance between the left and right channels is adjusted with the Balance
rotary encoder; the current balance setting is indicated by the adjacent purple
bargraph.
DJ / Guest phone Volume The headphones volume is adjusted with the two Volume rotary encoders;
the current volume setting is indicated by the adjacent purple bargraphs.
Depending on the configuration, individual talkback to the DJ and the guest
headphones may be selected; in such a case, the PFL speaker(s) is/are mut-
ed.
5.3.5.4 (Monitoring) CR CUE Page
CUE (1...8) Sends the selected CUE feed to the corresponding N–X bus.
CR MON Selects the signal that has been selected for CR monitoring as a CUE signal
(corresponds to the “Follow CR” function on other monitoring pages).
10 Cue Source Buttons (below CR MON)
(Configurable in ConfigGUI/DeskCommon/Cue-Keys)
Select the source that is fed as the cue signal. The 10 sources displayed on
these buttons are pre-selected during system configuration (DeskCommon
– Cue Keys page).
To Next Page
Loading...
