5.10.8 Internal Access Handling
The extensions providing the interface to the user are responsible for checking
the corresponding privileges.
5.10.8.1 User GUI
The user GUI extension checks the privileges on two different levels, i.e.
for pages and for console parameters. For a user having no access right to a
certain page, this page will not open. Access to a console parameter depends
of the current privilege flag setting:
Grant The corresponding button or the black parameter value field above the rotary
encoder is visible and allows controlling this parameter.
Deny The corresponding button or the black parameter value field above the rotary
encoder is not visible, there is no way for controlling this parameter.
Special Cases:
Parameters without Privileges There exist console parameters without privileges, such as fader level, channel
on/off, PFL). These parameters can be controlled from the user GUI whenever
access to the corresponding page is granted.
Access The Access button on the CHAN - Input page allowing the user to request
access to the microphone inputs’ unique resources is visible only if access to
at least one of these parameters is granted.
Insert ON/OFF The privilege for the Insert ON/OFF buttons on the CHAN - FDR/Bus and
the Sum - Master pages is defined in the ROUT::Insert section. Therefore
the Insert ON/OFF button for a certain logical input or master is visible only
if the user has access to the insert currently assigned to that logical input or
master.
Input Routing The input routing (strip assignment) can be controlled from both the CHAN -
Input and the Routing - Input pages. The ROUT::Input - All Parameters
privilege provides access to the strip assignent on both pages.
As a consequence, the CHAN - Input page and the Input Selection button
on this page can be accessed under the following conditions:
• For logical inputs:
• The CHAN - Input page is accessible if either the ROUT::Input - All
Parameters privilege or at least one of the CHAN::Input privileges
are granted.
• The Input Selection button on the CHAN - Input page is visible if
the ROUT::Input - All Parameters privilege is granted.
• For all sum buses:
• The CHAN - Input page is accessible if the ROUT::Input - All Par-
ameters privilege is granted. Any SUM::... privileges are ignored.
• The Input Selection button on the CHAN - Input page is always
visible.
To Next Page
Loading...
Need help?
General
